Download Micromax Bharat 2 Plus Firmware For Unbrick And Update

0 171

We are sharing Micromax Bharat 2 Plus Q402 Firmware, Driver, and Tool in this post. Here we have shared the official Micromax Bharat 2 Plus Firmware for unbricking and updating. You can also update your Micromax Bharat 2 Plus smartphone and revert back to stock firmware, also If your Device Brick or Bootloop after installing Custom Rom’s Kernels or anything customized this firmware will Unbrick Bharat 2 Plus Q402+.

1x1.trans - Download Micromax Bharat 2 Plus Firmware For Unbrick And Update

The previous year, Micromax released Micromax Bharat 2 Plus with Android 7.0 (Nougat). This device runs on Quad-core Speadtrum processor and it comes with 1GB of RAM. Micromax Bharat 2 Plus comes with 4.0 inches Capacitive touchscreen of 480 x 800 pixels. It has 1 GB of internal storage. The storage can be expandable up to 8 GB.

The Micromax Bharat 2 Plus gives you 5-megapixel rear camera to capture a good quality image and 2-megapixel in front facing the camera for selfies. The Bharat 4 is more than a phone. It has removable Li-Ion 1600 mAh battery. The sensors in this device are an Accelerometer.

If you face any lag of your device and network issue then follow the guide and install this stock firmware. This stock firmware fixes any issue and unbrick Bharat 2 Plus Q402+. Stock firmware doesn’t void the warranty of your Micromax Bharat 2 Plus Q402+. So let’s go to the instruction to download Micromax Bharat 2 Plus Firmware.

Micromax Bharat 2 Plus Firmware Details:-

  • Android Version: Android 7.0
  • Android Name: Nougat
  • UI Version: Stock UI
  • Release Date: 26.12.2017
  • Model: Micromax Bharat 2 Plus
  • Country: All.
  • Status: Official
  • File Size: 980 MB
  • Firmware link: MMX_Q402+_RU_SW_V01_HW_V3.0_20171226.zip

Guide To Install Firmware:-

  • Extract downloaded.zip (firmware file).
  • Install Spreadtrum USB drivers.
  • Now open SPD Upgrade File and run a setup file of SPD flashing tool (UpgradeDownload.exe).
  • Switch off your phone and connect your phone to the PC by pressing vol down key.
  • Then click the ” Load Packed ” button and browse and select the extracted firmware [.pac] file which you have already downloaded.
  • Now hit the Start Downloading button.
  • After the flashing, a green pass message will appear.
  • Disconnect your phone and turn it on.
You May Also Like:
Note: The first time it takes 5-10 minutes to boot.
If you face any problem please comment below, we will happy to help you.

Leave A Reply

Your email address will not be published.